This week, the nature of my main task changed a little. From developing the remoteproc driver for X86 architecture I’m now required to do it for the raspberry pi which uses an ARM processor. This is because the main product of our company is not completely ready, and my supervisor Read more…
After putting my current project on halt for a week time, finally I’m back to track to work on my T3ras project. This week I focus mainly on the execute stage in pipeline to execute and manipulate each of the MicroBlaze instruction sets into semantics operation written in Java. Since Read more…
The above blinking LEDs are not regular blinking LEDs. These LEDs are connected to the output of a GPIO. That GPIO is controlled by the AEMB2 microprocessor and the AEMB2 microprocessor is fetching it’s instructions from a 16K block RAM that has been loaded with data using the DATA2MEM software. Read more…
Finally! After another week I managed to force the module to work (correctly!). I had a really hard time debugging it, since you can’t simply expect to find a mistake by looking at seemingly random combinations of 163bits. I was forced to run again and again through the whole code Read more…
First Modification (29 June 2013) Three text files are created with size of 35 KB, 175KB and 350 KB. The files were created by simply duplicating the whole 35 KB text file five times and 10 times respectively. By using the Timer1 module created last week, the read time for Read more…
There goes another week. Task for this week is quite similar to last week’s, I was asked to write a MSPI driver. Before I started, I had no idea what it is and what does it do, so I was waiting for my supervisor to fill me up with all Read more…
Previously, the PIC18 was programmed to emulate 3 separate slave SPI devices – an ADC, a Flash memory and an Ethernet controller! The final task proved to be a notable challenge, and remained only partially implemented by the end of the week. This episode: there will be a double dosage Read more…