The project becomes closer to completion with the top level creator being as done as possible. In this post I’ll start by explaining the top level creator and it’s awkward status of being “as done as possible”. Next, I’ll try to make the big picture of our project clearer by Read more…
The optimization of the firmware continued with the focus being on the SD card reading stack. A look into the USART’s synchronous mode functionality was also taken to try and understand how that works. There was also a lot of time spent trying to set up scenarios to break the Read more…
Following the completion of the Ping-Pong Upload mechanism, its time to step forward to system optimization for the PIC firmware. This includes many separate portions looked into during the week to try to enhance the system performance and deliverable. The tasks include: i)optimization of the read/write functions ii) clearing up Read more…
My journey with C++ continues with three engines up and running. The bitgenerator, the software encoding bitstreams to suit our system. The software loader which runs data2mem to load the elf file into the RAM blocks on the bitstream. Last but nor least the synthesizer which runs Xilinx command line Read more…
As mentioned last week, the basic logic for the mechanism was devised within the PIC but it needed to be integrated to store and receive information on where the correct version of the file is saved onto the SD card from the card’s MBR itself. The biggest challenge to this Read more…
For a short period of time I’ll be writing a couple of C++ programs to do some tasks in our project. The first of them is what took my time this week and it’s more or less playing around with a bit stream. In this post I’ll explain what are Read more…
The test proceed into testing whether the slave modules are able to perform at high speed, without manual inputs. First, I initialize the Python code on the RPi to 25 MHz and I try to verify the functionality of the module. But, before that I found the ADC modules has Read more…
Following the functionality of the Base64 decoder and CRC checked writing process, it was time to move onto the next step to reach the objective set for the month. The next step is to integrate two specific portions into the current code; i) the Ping-Pong Upload mechanism and ii) Reading Read more…
This week I’ve fully completed I2C master and slave and tested them by simulation. Having been over that I’ve moved to learning C++ object oriented programming to write the code that creates the system top level code. There isn’t much to say about C++ so I’ll use this blog post Read more…
This week ended up being highly productive as it culminated into the completed functionality of the file upload system with Base64 decoder and CRC support. However, it was not always plain sailing during the week and much time, effort and attention to detail was needed to debug the existing code. Read more…