This week was a real eye opener in many ways. Physically I was unwell, and mentally I was fatigued. But it throughout the week, I picked up a lot of advice from the supervisor and I hope I was able to implement some of them in my work this week. Read more…
Running to the bus-stop to try to catch the 9:00am UCSI bust before it runs away, all I could think was “God, I don’t want to be late on the first day!”. But the butterflies in my stomach gave me enough of a kick to get on the bus in Read more…
After adding the software SPI, I started out writing the program. There are four working modes in SPI and the SPI timings for Mode 0 is the proper setting for the SD Cards. After setting the mode I started defined the values for the commands that are to be used. Read more…
I was still working on the SD card this week. I took up from where I left off and started with setting up the SD card. I soldered the pins onto the little board for holding the card. This board has a pre-made insertion point for the card and which Read more…